![]() These stud designations are intended to indicate the "on-center" position of framing members. You will rarely use these markings unless you happen to be building a shed or playhouse, or constructing partition walls during major remodeling projects. These increments correspond to the common intervals for the studs, joists, and rafters that are used to create the basic structural framework for walls, floors, and roofs. Find the Stud Markingsįor the benefit of framing carpenters who do repetitive work, most tape measures also have convenient markings at 16-inch and 19.2-inch increments, usually designated by a number highlighted in red, or by a small diamond marking on the blade. 1/16- and 1/32-inch increments are more often used in fine woodworking projects where hardwood workpieces need to fit very tightly. When framing walls, for example, tolerances down to 1/8-inch are usually completely sufficient to bang studs and joists into place. Stretch your measuring tape across the object. Use each of the smaller marks to find the length in millimeters. For metric units, measure centimeters with the longest markings. Use the next longest lines for inches, the third longest for inches, and so on. On dual-purpose tape measures, the numerals on the opposite side of the blade indicate centimeters.įor general construction work using framing lumber, it's usually sufficient to measure down to 1/8-inch increments. For imperial units, use the longest marks to measure inches.On some tape measures, the inch markings repeat 1- to 12-inch increments on one side of the blade, with running inch increments on the other side (as shown here). ![]() Inch marks are usually in the largest font.At 8 feet, for example, you will see both a "8 ft." and a "96" inch designation. Inch mark numbering usually continues along the entire length of the blade. The next increments of measure on a tape measure blade are the inch marks, which will be identified by the longest lines and usually labeled with a single numeral-1, 2, 3, etc. It's the same thing, but a little easier to read on the tape and remember. So, instead of a ceiling being measured as 7 feet, 6 inches, it would be measured as 90 inches. How much is 2.37 inches in millimeters We have already seen how to convert these two values and how change inches to millimeters. That way, you only need to pay attention to one set of figures: inches. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |